[ausev] !12-Volt Ice cooling with a Icester by Swampy.

[Linda Thorne]

Please remove me from your mailing list.  Although I am interested in
the electric cars, I need to cut down on my daily email.  Good luck to
you all!

Linda Thorne
Professional Forex Trader and Mentor 
 
Office:     512-345-8035
Mobile:     512-470-3435
Fax:         512-345-8035
lcthorne at sbcglobal.net
 
Forex trading has large potential rewards but also large potential risk.
See disclaimer at http://www.ForexTradersEdge.com.
 

-----Original Message-----
From: ausev-bounces at austinev.org [mailto:ausev-bounces at austinev.org] On
Behalf Of Chris Cooper
Sent: August 24, 2006 9:38 AM
To: AustinEV News Announcements and General Discussion
Subject: Re: [ausev] !12-Volt Ice cooling with a Icester by Swampy.

Nor enough surface area; would not provide enough cooling ability.
Perhaps that and cubed ice?

C²

-----Original Message-----
From: ausev-bounces at austinev.org [mailto:ausev-bounces at austinev.org] On
Behalf Of mark witt
Sent: Wednesday, August 23, 2006 4:23 PM
To: ausev at austinev.org
Subject: Re: [ausev] !12-Volt Ice cooling with a Icester by Swampy.

How about using half gallon or gallon clean plastic milk jugs filled
almost 
full and frozen and lay them in the bottom of the cooler.Easy to reuse
and 
the gallon jugs stay frozen along time. I use them to augment my ice
supply 
on camping trips or to keep stuff cold in the Airstream between plugins
of 
the refrigerator. Witt


>From: "Chris Cooper" <chris.cooper at mail.utexas.edu>
>Reply-To: AustinEV News Announcements and General 
>Discussion<ausev at austinev.org>
>To: "AustinEV News Announcements and General Discussion" 
><ausev at austinev.org>
>Subject: Re: [ausev] !12-Volt Ice cooling with a Icester by Swampy.
>Date: Wed, 23 Aug 2006 12:32:50 -0500
>
>These things are so easy and cheap to build. I have built two of them;
one 
>large enough to cool my old '86 dodge van. I pumped ice water from the
ice 
>chest through the heater core.
>
>You need (basically):
>Ice chest
>Smallest 12V bilge pump from Wal Mart
>Some 1/2" through-wall barb connectors
>1/2" water hose
>Heater core with 1/2" fittings
>12V fan attached to the heater core or use the heater core in the
vehicle
>Large and small pieces of ice
>About 3" of water in the bottom of the ice chest
>
>
>
>C²
>
>-----Original Message-----
>From: ausev-bounces at austinev.org [mailto:ausev-bounces at austinev.org] On

>Behalf Of Richard Slatin, MC/MFCT
>Sent: Wednesday, August 23, 2006 9:19 AM
>To: kevin.koym at enterpriseteaming.com; ausev at austinev.org
>Subject: [ausev] !12-Volt Ice cooling with a Icester by Swampy.
>
>Hello Kevin,
>
>I live in Phoenix, AZ, where the summer heat tops 110F, often.  I'm
>rebuilding the Bradley GT2 Electric, which is a 96v-based EV.  I, too,
>and in search of the holy grail of EVs, a car that handles the daily
>commute (40-55 miles per charge) and can keep me cool in the heat.  My
>research--and searching--led me to the unit below.  I haven't purchased
>it yet, but plan to have it for next summer's heat season.  It draws
>relatively few amps.  You may want to have your club members look it
>over, and I'd welcome their input.
>
>Regards,
>
>Richard in Phoenix
>
>
>http://www.swampy.net/ac12.html
>
>_______________________________________________
>AusEV mailing list
>AusEV at austinev.org
>http://www.austinev.org/mailman/listinfo/ausev



_______________________________________________
AusEV mailing list
AusEV at austinev.org
http://www.austinev.org/mailman/listinfo/ausev