[ausev] Heat Sink

[Mike Delany]

The fins are about an inch and a half high and three quarters of an inch 
apart.  I don't think that it will work.  You might try using a piece of 
aluminum plate with several big computer heat sinks.

Mike

Certified heathen and reformed pacifist

http://www.p1800s.com

On Fri, 14 Sep 2007, Wieser Scott wrote:

> I need about 400 square inches.  How tall, thick, and far apart are the
> fins?
>
> Thank you,
>
> Scott Wieser
> Office   512-460-8611
> Mobile  512-293-3949
>
> -----Original Message-----
> From: ausev-bounces at austinev.org [mailto:ausev-bounces at austinev.org] On
> Behalf Of Mike Delany
> Sent: Friday, September 14, 2007 5:31 PM
> To: AustinEV News Announcements and General Discussion
> Subject: Re: [ausev] Heat Sink
>
> How big of a heat sink do you need.  I have a couple of old big finned
> heatsinks that are about 4 inches wide and 3 feet long.  I can cut piece
>
> off if you need some.  For aluminum plate, you can try Westbrook metals
> by
> Airport and Lamar.  Closed on Saturday but they will cut for you.  What
> size do you need?
>
> Mike
>
> Certified heathen and reformed pacifist
>
> http://www.p1800s.com
>
> On Fri, 14 Sep 2007, Wieser Scott wrote:
>
>> Hello,
>>
>> I am having a hard time finding the controller heat sink and aluminum
>> plate.  Do you know where I can find that?
>>
>> Thank you,
>>
>> Scott Wieser
>> Office   512-460-8611
>> Mobile  512-293-3949
>>
>>
>> _______________________________________________
>> AusEV mailing list
>> AusEV at austinev.org
>> http://www.austinev.org/mailman/listinfo/ausev
>>
> _______________________________________________
> AusEV mailing list
> AusEV at austinev.org
> http://www.austinev.org/mailman/listinfo/ausev
>
> _______________________________________________
> AusEV mailing list
> AusEV at austinev.org
> http://www.austinev.org/mailman/listinfo/ausev
>