[ausev] Ive discovered my scooter is over unity!!!

[Matt]

Most likely, the battery pack voltage is drooping under high current (high
load), and the reference voltage for the battery meter is drooping as
well.  The measurement is only as accurate as its reference. I would
investigate how you are powering your voltage meter and where it gets its
reference from.

Matt

On Fri, May 15, 2009 6:20 pm, Chris Robison wrote:
> Some questions:
>
> What is the make and model of your scooter? At what points in the system
> are you placing your probes or clips? Can you reproduce the behavior on
> a stand (with the rear wheel raised)?
>
> I could imagine motor regeneration causing temporarily higher voltages,
> but if your 64V pack is "sitting" at 110V after shutting down, I'd guess
> you either have a measurement error or a battery pack that won't last
> long.
>
>   --chris
>
>
>
>
>
> Aaron Richardson wrote:
>> I put a volt meter on my pack to see how much its sagging under load.  I
>> see the resting pack voltage is about 64V (5x12v SLA).  When I
>> accelerate the pack sags down to about 55 or so and then climbs as the
>> scooter increases speed.  On a freshly charged pack it got to 110V!!
>>
>> I dont think Im inducing current into my sense wires because the voltage
>> goes to 64V when I let off the accelerator and coast at high speed.  It
>> seems this voltage it right.  If I shut the scooter off then this is
>> where the pack sits.
>>
>> So, whats causing this voltage and can I trust the sag voltage when the
>> scooter is moving very slowly?
>>
>> thanks,
>> Aaron
>>
>>
>> _______________________________________________
>> AusEV mailing list
>> AusEV at austinev.org
>> http://www.austinev.org/mailman/listinfo/ausev
>>
>
> _______________________________________________
> AusEV mailing list
> AusEV at austinev.org
> http://www.austinev.org/mailman/listinfo/ausev
>